GUTR-HH Wearing Instructions

 
FASTENERS Do not separate “loop” fasteners from sweatband during installation.

FASTENERS

Do not separate “loop” fasteners from sweatband during installation.

PREPARATION Remove suspension from hard hat and prepare area on both sides for installation. Use included wipe to remove any oil or grease. Use included sandpaper to roughen area. 

PREPARATION

Remove suspension from hard hat and prepare area on both sides for installation. Use included wipe to remove any oil or grease. Use included sandpaper to roughen area. 

ALIGNMENT Align front of sweatband along front of suspension to determine where to install “loop” fasteners. Remove protective plastic and attach fasteners as shown, pressing firmly. 

ALIGNMENT

Align front of sweatband along front of suspension to determine where to install “loop” fasteners. Remove protective plastic and attach fasteners as shown, pressing firmly. 

FITTING Put suspension on without shell. Adjust straps until front of sweatband is snug across forehead.

FITTING

Put suspension on without shell. Adjust straps until front of sweatband is snug across forehead.

INSTALLATION Reinstall suspension and use helmet fastening system to adjust sweatband tension. Secure using the fastener.

INSTALLATION

Reinstall suspension and use helmet fastening system to adjust sweatband tension. Secure using the fastener.